Duet 3D

From Wizard Rants
Revision as of 21:35, 15 June 2020 by Northrup2 (talk | contribs) (created reference for how to setup PanelDue 7i on RepRap v3.1 firmware.)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

PanelDue 7i

When running RepRap 3.1 or later your config.g must now contain explicit statements about the baud rate for the panel. For the Duet 3D 3 6HC board the following is correct

M575 P1 S1 B57600

This sets the M575 command for the IO_0 port.

Retrieved from "https://wiki.8bitwizard.net/index.php?title=Duet_3D&oldid=85"