Duet 3D: Difference between revisions
Jump to navigation
Jump to search
created reference for how to setup PanelDue 7i on RepRap v3.1 firmware. |
adding digi-key parts for stepper motors on Duet 3 |
||
| Line 1: | Line 1: | ||
==== PanelDue 7i ==== | ==== Duet 3 6HC Main Board ==== | ||
Connector parts can be found from Digi-Key | |||
Stepper Motor Connector: VHR-4N / 455-1185-ND | |||
Stepper Motor Connector Pins: SVH-41T-P1.1 / 455-1319-1-ND | |||
====PanelDue 7i==== | |||
When running RepRap 3.1 or later your config.g must now contain explicit statements about the baud rate for the panel. For the Duet 3D 3 6HC board the following is correct | When running RepRap 3.1 or later your config.g must now contain explicit statements about the baud rate for the panel. For the Duet 3D 3 6HC board the following is correct | ||
Revision as of 21:52, 15 June 2020
Duet 3 6HC Main Board
Connector parts can be found from Digi-Key
Stepper Motor Connector: VHR-4N / 455-1185-ND
Stepper Motor Connector Pins: SVH-41T-P1.1 / 455-1319-1-ND
PanelDue 7i
When running RepRap 3.1 or later your config.g must now contain explicit statements about the baud rate for the panel. For the Duet 3D 3 6HC board the following is correct
M575 P1 S1 B57600
This sets the M575 command for the IO_0 port.