Duet 3D: Difference between revisions
Jump to navigation
Jump to search
adding digi-key parts for stepper motors on Duet 3 |
m formatting of a referenced file on a file system. |
||
| Line 1: | Line 1: | ||
==== Duet 3 6HC Main Board ==== | ====Duet 3 6HC Main Board==== | ||
Connector parts can be found from Digi-Key | Connector parts can be found from Digi-Key | ||
| Line 7: | Line 7: | ||
====PanelDue 7i==== | ====PanelDue 7i==== | ||
When running RepRap 3.1 or later your config.g must now contain explicit statements about the baud rate for the panel. For the Duet 3D 3 6HC board the following is correct | When running RepRap 3.1 or later your <code>config.g</code> must now contain explicit statements about the baud rate for the panel. For the Duet 3D 3 6HC board the following is correct | ||
<code>M575 P1 S1 B57600</code> | <code>M575 P1 S1 B57600</code> | ||
This sets the [https://reprap.org/wiki/G-code#M575:_Set_serial_comms_parameters M575] command for the IO_0 port. | This sets the [https://reprap.org/wiki/G-code#M575:_Set_serial_comms_parameters M575] command for the IO_0 port. | ||
Latest revision as of 09:21, 27 June 2020
Duet 3 6HC Main Board
Connector parts can be found from Digi-Key
Stepper Motor Connector: VHR-4N / 455-1185-ND
Stepper Motor Connector Pins: SVH-41T-P1.1 / 455-1319-1-ND
PanelDue 7i
When running RepRap 3.1 or later your config.g must now contain explicit statements about the baud rate for the panel. For the Duet 3D 3 6HC board the following is correct
M575 P1 S1 B57600
This sets the M575 command for the IO_0 port.